Homepage
The RCJ16 flush-mounted receiver is designed to switch low-voltage or mains voltage devices on and off. A total of 32 transmission codes can be programmed into the receiver's memory.

All programmed transmission codes are combined according to an AND/OR logic:

AND combination
If all of the programmed transmitters send a B telegram (OFF), the relay switches off.

OR combination
If one of the programmed transmitters sends an A telegram (ON), the relay switches on.

RCJ16E5001-01-23K
Technical specifications
Coding Easywave
Up to 32 transmitters can be programmed.
Frequency 868,30 MHz
Channels 1
Power supply 230 V AC, 50 Hz
Power consumption 0,25 W standby
0,80 W relay switched (without load)
Operating modes AND/OR
Outputs 1 potential-free relay contact (changeover)
Maximum contact load see table of loads
Operating temperature -20 °C to +60 °C
Dimensions 48 x 48 x 25 mm
Scope of delivery
  • Flush-mounted receiver
  • Operating manual
Models
Product numbers Description
RCJ16E5001-01-23K Flush-mounted receiver, Easywave, 230V, 1x changeover, potential-free, AND/OR logic
Wiring diagram


 
Table of Loads
type of load max. load
resistive load: lamps, 230 V halogen lamps etc. 10,0 A / 2.300 VA
inductive load: halogen lamps with wound transformers
(min. load of transformer 85%)		 3,0 A / 690 VA
non- or serial-compensated fluorescent lamps with ferromagnetic ballasts 6,0 A / 1.380 VA
parallel-compensated fluorescent lamps with ferromagnetic ballasts 3,0 A / 690 VA
capacity EVG: electronic cut-in units, electronic transformers etc. 6,0 A / 1.380 VA